How to reset the Robin SV, Robin SIP or Robin SlimLine to factory defaults

To reset the Robin SV, Robin SIP or Robin SlimLine back to factory defaults do the following:

 

- Disconnect the Robin from the Power over Ethernet switch or midspan

- Reconnect the Robin

- After the startup tone sounds press the ring butten 6 times within 10 seconds, ignore the ringing sounds!

- The Robin  will reboot automaticaly. After reboot the Robin is back to factory defaults

 

* Note: When restored to factory defaults, the Robin uses DHCP to resolve an IP address!

This will not work on the Keypad with software version below 3.6.4.

Article Details